change your ip address

1. Click on "Start" in the bottom left hand corner of screen 
2. Click on "Run" 




3. Type in "cmd" and hit ok
You should now be at an MSDOS prompt screen.

4. Type "ipconfig /release" just like that, and hit "enter" 
5. Type "exit" and leave the prompt 
6. Right-click on "Network Places" or "My Network Places" on your desktop. 
7. Click on "properties You should now be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks. 
8. Right click on "Local Area Connection" and click "properties" 
9. Double-click on the "Internet Protocol (TCP/IP)" from the listunder the "General" tab 
10. Click on "Use the following IP address" under the "General" tab 11. Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the area up). 
12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers. 
13. Hit the "Ok" button here 
14. Hit the "Ok" button again You should now be back to the "Local Area Connection" screen.
15. Right-click back on "Local Area Connection" and go toproperties again. 
16. Go back to the "TCP/IP" settings 
17. This time, select "Obtain an IP address automatically" tongue.gif 18. Hit "Ok" 
19. Hit "Ok" again 
20. You now have a new IP address With a little practice, you can easily get this process down to 15 seconds. 
 Suggesion :- “This only changes your dynamic IP address, not your ISP/IP address. If you plan on hacking a website with this trick be extremely careful, because if they try a little, they can trace it back.”